Ghost Immobiliser

Quick, Simple and User Friendly The Ghost Immobiliser is perhaps the most comprehensive vehicle security available. On top of this it is extremely user friendly. Your pin will be unique to you, making it simple to remember – but mathematically impossible for a thief to guess. In addition, if you do forget your PIN your engineer will have provided with an Emergency PIN Code override. Simply scratch this off the card and follow the instructions to reset your PIN. Fully reversible Your Autowatch Ghost Immobiliser can be removed and reinstalled in a new vehicle without any indication that it was ever there. Your Ghost Immobiliser is connected directly to your vehicle’s CAN (Controller Area Network). From there a customised PIN is generated specifically for you. This PIN is a unique private sequence, using buttons on your dash and steering wheel. This means only those who know the combination are able to start your vehicle. Stealth Silent Operation   With a Ghost Immobiliser installed there is now way a thief will be able to detect the ‘tell-tale’ clicking of a traditional immobiliser. This is because your Ghost Immobiliser communicates directly with the ECU on the data bus to immobilise your vehicle. The Ghost Immobiliser is weatherproof and so small that it can be combined in to the vehicles mechanism making it practically impossible to detect. Engine Start Blocking  Your Autowatch immobiliser prevents the starting of your vehicle unless the user has entered the user generated PIN. This is even if they have the keys with them, protecting your vehicle against key theft, keyless entry and key cloning. No Detectable RF Signals or Diagnostics Thieves can use Radio Frequency Scanners to detect the fitted security on the vehicle. Your Ghost Immobiliser does not transmit and detectable radio frequency signals, making it undetectable under these circumstances. Organised car thief gangs can detect circuit cuts on vehicles using diagnostics reading devices. The Autowatch Ghost Immobiliser does not involve any circuit cuts, so is once again undetectable to thieves using this method Service Mode You may need someone else to drive your vehicle temporarily (e.g. valet parking) or when your vehicle is being serviced. In such an instance you can set ‘Service Mode’, allowing your vehicle to be started and driven without the need for the PIN. Uses the CAN Bus (Controller Area Network) Using the CAN Data Bus means a low likelihood of your Ghost immobiliser being found as well as simple / reversible installation. Within a couple of drives you’ll be totally familiar with your Autowatch Ghost immobiliser and it will just be another part of starting your car…. but with the added security … and full peace of mind!! Nationwide mobile installation included Disarm sequence via buttons on steering wheel/dash No transmitted radio frequency signals Immobilisation by communicating with the ECU Uses the on-board CAN data network User changeable disarm sequence Service / Valet mode for when you need others to use your vehicle Secure and unique emergency code for if you ever forget your disarm sequence 2 Year Warranty as standard  If you need a Ghost immobiliser and tracker then take a look at our vehicle security packages for the best options